MIDAS XCI System

What is Immersion Cooling?

Immersion cooling is the process of removing heat from data servers and other components by submerging them in a non-conductive heat transfer liquid. Through years of research and development, Midas has enhanced this process to provide the most effective immersion cooling equipment solution on the market.

Constant Improvement
Commitment to Customers
Quality

The MIDAS XCI System

Electronic components are submerged in a dielectric liquid where heat from the electronic components is transferred to the fluid. Pumps are used to flow the heated fluid to a heat exchanger, where it is cooled and cycled back into the enclosure.

Immersion Tank

The tank performs the function of a server rack. Designed to have everything necessary to run servers inside its footprint. Engineered to ensure dielectric fluid stays inside the tank and for efficient cable management.

MIDAS XCI System

Designed to maximize server density and power efficiency with a minimal physical footprint, the MIDAS XCI System is over 1,200 times more efficient at dissipating heat than traditional air cooling methods. Each XCI immersion tank can be configured to cool up to 150 kW of compute power and can be located almost anywhere.

Cooling Module

A cooling module replaces the traditional cooling infrastructure. Hot-swappable modules can be rolled off for maintenance while a spare takes its place to maintain redundancy. This system provides
active redundancy and allows for concurrent maintainability. Additionally, dry disconnects enable clean and rapid module replacement.

Efficiency Benefits

Power Savings

10 %

Capex Savings

10 %

Space Savings

10 %

Previous slide

Next slide

Operational Benefits

Lower Power Consumption

Minimal Atmospheric Contaminants

No Server Fan Failures

Minimal Oxidation and Corrosion

Low Noise

High Water Usage Efficiency (WUE)

Technical Benefits

Future Proof

Eco-friendly

Scalable

Reliable

Redundancy & Concurrent Maintainability

Supremely Durable

Cooling Comparison

MIDAS vs Other Cooling Solutions

The only system that allows concurrent maintainability.
Modular design & scalability at any rate.
Upgrade or downgrade individual systems from 1N, 2N, or 2N+1 as needed.

Redundant cooling modules can be replaced in less than 10 minutes without tools.
Patented technology with superior heat transfer for maximum efficiency.

Immersion vs Air Cooled

	Uptime Inst*	Hyper / Colo	Immersion
PUE	1.55	1.35	1.05
Standard Server Consumption	1000 W	1000 W	1000 W
Minus Fans (5%)	0 W	0 W	150 W
Actual Server Consumption	1000 W	1000 W	850 W
Cooling Consumption	550 W	350 W	42.5 W
Total Power Consumption	1500 W	1350 W	892.5 W
Immersion SAVINGS vs Air Cooled	42%	34%	- -

*2022 Uptime Institute survey average

MIDAS vs Other Cooling Solutions

Cooling Technology	Water Usage Efficiency	Future Proof	No Extreme Components Temperature Change	No Humidity Issues	IT Equipment Reliability	Mean Time to Repair (MTTR)	Capital Cost	Typical PUE
Conventional Air Cooling								1.6
Air-Side								1.3 - 1.4
Water - Side Economization								1.4 - 1.5
Adiabatic (Evaporative)								< 1.2
Liquid to the Chip								< 1.2
Single Phase Dielectric Cooling								< 1.05
2-Phase Dielectric Cooling								< 1.05